Minitab would perform the statistical analysis for the data (find mean, variance...etc) from there on it's a simple plug and chug to get the capability indices Amol Kane M.S (Industrial Eng.) Process Engineer Harvard Custom Manufacturing 941 Route 38 Owego, NY 13827 Phone: (607) 687-7669 x349 [log in to unmask] -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of bob wettermann Sent: Thursday, February 16, 2006 1:24 PM To: [log in to unmask] Subject: [TN] Machine Capability Study Software and Procedures Dear Technetters: We recently commissioned a machining center that is used on a job shop basis for a variety of customer work. Does anyone have a recommended procedure for completing a machine capability study? How about a recommendation on the SW to input the data? Any recommendations would be helpful. Regards Bob Wettermann BEST Inc Bob Wettermann --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 ----------------------------------------------------- PH 847-767-5745 --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------