Thank you all.
 
So should I do one of the following:
 
- Replace the solder pot altogether (the safest method, but most expensive)
- Clean the existing cast iron pot as best possible then fill with Pb Free solder (higher risk, but less expensive)
 
If anyone has cleaned their existing cast iron  solder pot, then how did you do it exactly? Is there a proposed method for doing this somewhere out there?
 
Any suggestions would be very helpful.
 
CAS

	-----Original Message----- 
	From: [log in to unmask] [mailto:[log in to unmask]] 
	Sent: Fri 12/9/2005 11:10 AM 
	To: Schaefer, Chris; [log in to unmask] 
	Cc: 
	Subject: Re: [TN] Preparing Solder Pot for Lead Free Processing
	
	
	Hi Chris,
	Pb left in the old 'pot' may not be your biggest problem--look at these pics.
	 
	
	
	
	Regards,
	Werner Engelmaier
	Engelmaier Associates, L.C.
	Electronic Packaging, Interconnection and Reliability Consulting
	7 Jasmine Run
	Ormond Beach, FL 32174 USA
	Phone: 386-437-8747, Fax: 386-437-8737, Cell: 386-316-5904
	E-mail: [log in to unmask], Website: www.engelmaier.com