It's Monday... had your coffee yet? I'm trying to gather together some potential solutions to High Voltage breaking over and arcing between traces on board. The things I know contribute to this are things like, too little spacing between traces on the surface or in the inner layers, sharp points on traces, board cleanliness or the presence of contaminants between the potential voltages. It was suggested that conformal coating the boards after a real good cleaning might improve the insulation resistance between traces, has anyone done this successfully? Do you have any other ideas short of a re-layout of the board that could perhaps repair a problem like this? Any ideas are most appreciated. Bill Brooks - KG6VVP PCB Design Engineer, C.I.D.+, C.I.I. Tel: (760)597-1500 Ext 3772 Fax: (760)597-1510 Datron World Communications, Inc. _______________________________________ San Diego Chapter of the IPC Designers Council Communications Officer, Web Manager http://dcchapters.ipc.org/SanDiego/ http://pcbwizards.com --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------