Joel:
I beleive these connectors are available with solder bearing leads.  Then
all you have to do is add flux and send through a reflow oven.

If you must deal with the connectors you have, you might want to consider
solder preforms.  They should be available from your solder/flux supplier.
Then all you do is slip a solder preform (shaped like a washer) over each
pin and add flux (if its not already on the preform) and then send thru
your reflow oven.

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------