We define not only stencil thickness required per component area but also the aperture sizes and shapes...Typically we use component specifications, metal layer, soldermask layer and drill data, factoring the solder paste being used, to define the stencil we will use on particular PCA. Paul Edwards Process Engineering [log in to unmask] Tel: 408-433-4700 FAX: 408-433-9988 Surface Art Engineering 81Bonaventura Dr. San Jose, CA 95134 DUNS: 944740570 CAGE/NCAGE: 1XZ48 -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of Kotecki, George Sent: Thursday, September 29, 2005 12:05 PM To: [log in to unmask] Subject: [TN] Assembly data requirements To all: What has been your experience regarding solder mask data supplied to contract assemblers? Do they request or use customer supplied data or do they prefer to generate their own stencils based on volumes? This is just an informal poll. Thanks in advance George Kotecki --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 ----------------------------------------------------- --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------