That's not a good pass/fail gate. You can avoid breakout while being
off on layer-layer by more than .005. What you achieve as an
annular ring is directly related to the board design (pad to drill ratio)
and it's not necessarily related to layer-layer registration.

On 15 Jun 2005 at 16:04, Peter Lee wrote:

Technet,

I am looking for an acceptance criteria on PCB layer-to-layer
registration. The pcb is 4 layer and 8x4". I was informed by our PCB
vendor that they can conform to +/-0.005" and the pass/fail gate is
no annular ring breakout. Can someone please confirm?



Rgds,

Peter

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV
1.8e
To unsubscribe, send a message to [log in to unmask] with
following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives
Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-
615-7100 ext.2815
-----------------------------------------------------
-- Thanks,
Eddie Rocha
South Bay Circuits
(480) 940-3125 x122

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------