All! We have a customer that has had a design that we did quoted for 1000 pieces by a fab vendor. We have a .013 finished hole with a .024 pad. We're saying that that is not a DFM problem. Any "GOOD "vendor should not choke on this. What say you? Thanks Deac KAW/USA Director, Business Development 39 Simon Street, Suite 4 Nashua, NH 03060 phone: (603) 886-8711 ext.202 fax: (603) 881-8763 Cell : (603) 557-7568 Web sites: www.kaw.com www.emistream.com "Real People .... Real Solutions ..... Real Success" --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------