We are looking to use lasers to de-panel assembled PCBs, the initial results look very good apart from a slight burning (obviously) on the edge of the laminate. The burn is just on the surface in most cases but can discolour the laminate up to ¼ mm into the PCB in the worst case. Does anyone have experience of this? What reliability issues can you foresee? By the way - Petrol (Gas) is currently almost $7 a gallon in the UK! Many thanks, Neil ________________________________________________________________________ This e-mail has been scanned for all viruses by Star. The service is powered by MessageLabs. For more information on a proactive anti-virus service working around the clock, around the globe, visit: http://www.star.net.uk ________________________________________________________________________ --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815 -----------------------------------------------------