IPC-2222, Section 9.2.2.2 and Table 9-3. Roger M. Stoops, CID+ Trimble Navigation Ltd., Dayton, OH, USA Ph: +01 937.245.5288 Fax: +01 937.233.7511 -----Original Message----- From: TechNet [mailto:[log in to unmask]]On Behalf Of Victor G. Hernandez Sent: Monday, March 29, 2004 10:26 AM To: [log in to unmask] Subject: [TN] Finished Hole Size vs Lead diameter Fellow TechNetters, Can someone guide me to an IPC document that make reference to Finish Hole Size versus lead acceptable lead diameter with respect to ROUND, RECTANGULAR and SQUARE Leads. I have a case in which the square lead deformed the PTH and minimal solder fillet is exhibited inside the barrel. At least in my opinion. In advance I thank you for your timely response in this matter. Victor, --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ----------------------------------------------------- --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 -----------------------------------------------------