I have a pretty simple, most likely dumb question: does the numerical designation for mesh size for solder mask screens increase with an increase in the "thread" thickness of the mesh (thus resulting in less deposit?) or increase with increasing opening in the mesh, or something entirely differ? Thank you for answering and thank you in advance for not laughing...in email...at my dumb question. Jana Carraway Portland, Oregon --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 -----------------------------------------------------