We are manufacturing a PCB that has some 0603 chip caps & resistors on the secondary side. We would like to glue them so that we can run them through the wave, however they are quite small and we have not glued anything smaller than 0805. Are there any aperture recommendations or other suggestions that would help to ensure success on this project? TIA David Baldwin C.I.D.+ --------------------------------------------------------------------------------- DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF DesignerCouncil. To set a vacation stop for delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------