Hi Ioan If you are building a LOT of these, an option would be to get a "singulator" punch machine from Wand (http://www.wandtool.com/punchtype.html) Very quick, very repeatable, low operator training requirements - but design the panel so it's either symmetrical, or the board only fits one way, otherwise an operator will eventually load one upside down and crunch it... regards, Graham Collins Process Engineer, Northrop Grumman Canada Corporation Halifax (902) 873-2000 ext 6215 >>> [log in to unmask] 12/10/03 10:58AM >>> Hi Technos, I am looking for a depanelizer. It could be a press, a router or any other technology. I want to assess both in-line and off-line machines. The panel is 18-up, routed, approx 6.1"x8.2", 0.031" thick. The insertion time is about 3 minutes, the depanelizer will have to keep up (not too difficult, I guess). Could you suggest anything? Thanks, Ioan --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ----------------------------------------------------- --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 -----------------------------------------------------