--------------------------------------------------------Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Steve Kelly
Sent: Thursday, October 23, 2003 5:57 PM
To: [log in to unmask]
Subject: [TN] Solder Joint StrengthI had a question from a customer today which I could not answer. Question was “ if a pin is soldered in a through hole with an annular ring of .010 is this a stronger joint than if the annular ring was .005” . Doesn’t this depend more on the soldering technique that the size of the ring? Thanks. Steve Kelly
PFC Flexible Circuits Limited
Ph: (416) 750-8433
Fax: (416) 750-0016
Cell: (416) 577-8433
E-Mail: [log in to unmask]