For manufacturers it all depends on the number of
zeros in a tolerance.
a +/-.002 is different then a +/-.0020. Everything
beyond the 3 position
is moot if 5 or below (5 or less round down).
(either that or a note stating the extent of the tolerance.
This may be debated, but this is the fact of
life.
Also tolerances should always have at least 1
clearance between the tolerance
and the very edge. In other words, you should
always be able to add a 1.
.002 + .001 = .003
.050 + .010 = .060 etc.
I've been on both sides of the fence and this was
always what I was told.
----- Original Message -----
Sent: Thursday, September 18, 2003 10:28
AM
Subject: [TN] Tolerances
I am in a debate over assumptions or general knowledge with
tolerances on a print. I want to know which way you interpret the
situation.
Say you a print that has a part that should measure .187 +/-
.002. Now your are measuring the part and the part measures .189 in a
three digit but .1894 in a four digital measurement. Would one assume
that the part is actually .1870 which would say that the part is oversized or
read tolerance only off of the third digit which would make the part
acceptable?
Thanks in advance.
Kat
---------------------------------------------------
Technet Mail
List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe,
send a message to [log in to unmask] with following text in the BODY (NOT the
subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery
of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To
receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]:
SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives
Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information,
or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
-----------------------------------------------------