Hi All, Aren't there per job microsection requirements in 6012 ? If so, I'd call that an adder. Regards, Mark Hargreaves -----Original Message----- From: Steve Gregory [SMTP:[log in to unmask]] Sent: Monday, September 15, 2003 11:11 AM To: [log in to unmask] Subject: [TN] Building Fabs to IPC-6012 spec's... Hi All! Just a general question; how much of a cost adder would be incurred building Class-2 fabs that comply with all the IPC-6012 specifications? Thanks! -Steve Gregory- --------------------------------------------------- Technet Mail List provided as a service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 -----------------------------------------------------