Hi Don!
I bet my new microblaster could do it. The manual says to use the same settings for epoxy as I do urethanes...and I've done a LOT of urethane coated assemblies over the past month or so...
-Steve Gregory-
I need some quick suggestions. I have a sensor assembly (metal body) with epoxy potting covering a header and wire terminations. The termination area is potted in epoxy, and the volume is about the size of a sewing thimble. The wires require rework. Is there a way to remove the epoxy to get to the wire terminations?
Any and all suggestions appreciated.
Don Vischulis
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------