Hi Don! I bet my new microblaster could do it. The manual says to use the same settings for epoxy as I do urethanes...and I've done a LOT of urethane coated assemblies over the past month or so... -Steve Gregory- > I need some quick suggestions. I have a sensor assembly (metal body) with > epoxy potting covering a header and wire terminations. The termination area > is potted in epoxy, and the volume is about the size of a sewing thimble. > The wires require rework. Is there a way to remove the epoxy to get to the > wire terminations? > > Any and all suggestions appreciated. > > Don Vischulis > --------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/html/forum.htm for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 -----------------------------------------------------