Steve,
Just
the lul before the storm, man!
You
can use fuming nitric to remove most anything (including skin, fingers, bone,
etc. if one is not careful) if you have the fume hood set-up and adequate safety
procedures. It works really nicely.
On the
other hand, you could go to http://www.dynaloy.com/products.htm and
buy some Uresolve Plus SG, set it up on a hot plate under a fume hood and get
quite good results for most molded plastic compounds. At least the
Uresolve Plus SG does not have the obnoxious odor that the Decap from Dynaloy
has.
Sorry,
have not made any attempt to smell fuming nitric.
Best
wishes
Steven
Creswick - Gentex Corporation
Zeeland, MI
Mornin' All!!
Been rather
quiet on the list over the past week or so, hadn't it? Either means everybody
is on vacation, or everybody is so busy building stuff without problems that
they don't have any spare time...like to wish that was the
case.
Anyway, about Plastic IC Decapsulation, is that something I could
do myself? If so, what sort of chemicals would I use? Or is this something
better left to be done by the people who do that for a living, like failure
analysis labs?
Thanks!
-Steve Gregory- ---------------------------------------------------
Technet Mail
List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe,
send a message to [log in to unmask] with following text in the BODY (NOT the
subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery
of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To
receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]:
SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives
Please visit IPC web site
http://www.ipc.org/html/forum.htm for additional information, or contact Keach
Sasamori at [log in to unmask] or 847-509-9700
ext.5315
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------