Hi
everyone,
Does anyone know
of an IPC standard that will tell what a plated thru-hole size should be
depending on the diameter of the component that will be inserted. Example
would be a pin header, or a certain wire size. Basically, how much
bigger do you make the hole to accommodate the size needed so that you will
get a good solder joint, and designed well for
manufacturing.
Thanks,
Jim
---------------------------------------------------
Technet Mail
List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe,
send a message to [log in to unmask] with following text in the BODY (NOT the
subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery
of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To
receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]:
SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives
Please visit IPC web site
http://www.ipc.org/html/forum.htm for additional information, or contact Keach
Sasamori at [log in to unmask] or 847-509-9700
ext.5315
-----------------------------------------------------