But pay attention to section 6.2, table 6.1, note 2 --- bottomside lead protrusion is waived on boards 2.3mm or greater, IF lead length is pre-determined, not prepped. Jason Gregory SMT Production Supervisor/ Integrated Product Team Leader LaBarge Inc. (918)459-2367 (918)459-2221 fax [log in to unmask] http://www.labarge.com Stefano Riccardi <stefano.riccardi To: [log in to unmask] @DIADIX.IT> cc: Sent by: TechNet Subject: [TN] pin lenght <TechNet@listserv .ipc.org> 07/09/2003 07:04 AM Please respond to "TechNet E-Mail Forum."; Please respond to Stefano Riccardi Hi a basic question: with a 2.5mm tick PCB, what is the minimun lenght of a THT component pin? Thanks --------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/html/forum.htm for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ----------------------------------------------------- --------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/html/forum.htm for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 -----------------------------------------------------