Hi Technetters, Pls inform if you know any std. or research on solder joints pull test for SMT components per shape type (0805, 1206, gull wing, plcc using force gauge (table with minimal force for each component). I think it should be per area (mm square ) of the connection between the PCB to the component termination. e.g. I am not askeing about HASS od HALT tests. Best Regards ROKAH Reuven Chief Engineer ECI Telecom LTD. Operations Division 30 Hasivim St. Petah-Tikva 49517 ISRAEL Tel: 972-3-9266734 Mobile:972-55-786734 Fax: 972-3-9266480 e mail: [log in to unmask] --------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/html/forum.htm for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 -----------------------------------------------------