What we have found is that all our contracts state
to use the latest Mil-spec
or the latest industry standard. That being
IPC.
We used to do all mil-spec designs, but now with
that line in our all contracts,
we haven't done it in a while.
That may not be here or there, but it is just a
little insight.
CR
Folks,
Brought this up some time ago and I recall the
thread wandered off to other
interesting topics...
How much work is
out there for QML shops??? We're 55110 approved and looking
at 31032...just
wanted to see if work here would increase, decrease...or
remain the
same???
Also, if there are any of you QML shops listening, are any of
you using DSCC
as your source for ISO maintenance
audits???
Thanks
Franklin
---------------------------------------------------
Technet
Mail List provided as a free service by IPC using LISTSERV 1.8e
To
unsubscribe, send a message to [log in to unmask] with following text
in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt
or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or
(MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet
Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please
visit IPC web site http://www.ipc.org/html/forum.htm
for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
-----------------------------------------------------