[log in to unmask]">

Hello everyone,

 

I am looking for some insight / guidance on installing and soldering a Grand Pacific Opto LCD (part # GPG128X64-NFPCELYX).  One of our customer's is using this part on a prototype and we are currently "hand soldering" the flex strip terminations to a pcb.  On two of the displays we've tried so far (on a total of 8 units) the flex strip terminations broke free from the flex circuit when soldering (too much heat???).  I have tried Grand Pacific Opto's website for application data but their site is currently being updated.  If any of you have used this type of component, please contact me offline with any advice.

 

Thanks in advance.

 

Rich Lasko

Badger Electronics

---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------