My customer has asked if it is possible to control the glue squeeze on covercoat openings 100% of the time to .0025 or less. The covercoat is an LFO-0110 from DuPont. The parts have approx. 250 SMT openings on the top and 300 on the bottom. Openings are normally .026 x .026 or .030 x .036. We are not allowed to laser. This is a volume part so whatever is suggested must be cost effective. We have tried various combinations of press pad make-ups and pre-baking of the covercoats. We hold about 95% of the pads to .0025-.003 but have not been able to guarantee 100%.

Thanks for your time.

 

Regards Steve Kelly

 

PFC Flexible Circuits Limited

 

---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------