-----Original Message-----
From: Ronald Currell [mailto:[log in to unmask]]
Sent: Wednesday, January 08, 2003 10:48 AM
To: [log in to unmask]
Subject: [TN] Question Re: Marking Defective Solder Joints

Hi,

 

I am setting up a QC Station between our Board Department and the Technicians, who install the PC Boards into Instruments.  I would like nonconformances marked right on the solder joints with a red marker.   If the ink is not removed prior to the re-work process, will the ink contaminate the Solder Joints?

 

I suspect that the surface tension of the solder will not allow contamination to occur.  What do you think?

 

Please reply to [log in to unmask].

 

Thanks,

 

Ronald G. Currell

Ludlum Measurements, Inc.

--------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/html/forum.htm for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 -----------------------------------------------------