Hi David,

I must agree with you. We are about to embark on assembling a 16-layer, .062" thick, VME card. That has been re-designed from a commercial card to a "ruggedized" COTS card. The assembly has 17 BGA's, some are ceramic BGA's with high-temp balls, and a few with eutectic balls...there are BGA's on both sides of this board...none are "mirrored" though...and that's a good thing.

We've been having meetings on manufacturability issues with assembly (this is not going to be easy), and the biggest thing that I've tried to stress, is that it has to be built right from the beginning...rework should not be an option.

But we have heard from our customer, that historically, 20% of the PowerPC processors on this assembly have needed to be replaced (there's 4 of these on the board). I don't know if the processors are dead, or if it because of a manufacturing defect, but they say in the past, that's what the rework percentage has been.

I'm absolutely freaking out about this!!! Especially when you see the density of this board...

From my own personal point of view, I think COTS needs to be re-thought...too many risks.

-Steve Gregory-

I am appalled by these atttepmts to "repair" a board. The amount of damage and degradation done to the circuit
poses a serious threat to the reliability, particularly for class 3 operation.

The concept of "repairable" finished SMT products is very misleading and potentaily dangerous.
The ability to repair circuits is a legacy from the old Mil Spec days and have no business in todays processes!
Smaller none repairable circuits must become the norm.

David A. Douthit
Manager
LoCan LLC


"Long, Thomas" wrote:

> Yes Mike.  I have done several with an Air-Vac.  The best way is to make
> sure you have solder above liquidus(use t-couple).   I would target a
> temp > 200 C for at least 30 seconds.  Since the Parylene will still
> have a good hold on the solder joints, you must shear through the joints
> using a spatula.  Once you get the hang of it, it is fairly simple and
> straight forward. Like I said, I have taken off quite a few with no
> problem on the pad side.  Some clean up of course is required prior to
> replacing a new part.
>
>                         Tom Long
>                         ITT Avionics
>                         Clifton, NJ
>
> -----Original Message-----
> From: WEEKES, MICHAEL HS-SNS [mailto:[log in to unmask]]
> Sent: Thursday, December 05, 2002 10:58 AM
> To: [log in to unmask]
> Subject: [TN] reworking paralyne (paraxylene) coated BGAs and uBGAs
>
> Hello fellow Technetters:
>
> Anyone have any experience removing  paralyne (paraxylene) coated BGAs
> and
> uBGAs with conventional air vac DRS 24 type hot air equipment - I tried
> conventional reflow profiles and it was very unsuccessful.
>
> [log in to unmask]


--------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/html/forum.htm for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 -----------------------------------------------------