I believed before Jacks email that this applied to machined pins, as in a knurled type. Those I would and have soldered. Charles Caswell -----Original Message----- From: Steve Gregory [mailto:[log in to unmask]] Sent: Sunday, October 27, 2002 2:32 PM To: [log in to unmask] Subject: Re: [TN] Press fit connectors requirements per IPC-A-610 Just a question to the list, How many of you out there thought that the criteria in IPC-A-610B pub Dec 94 and currently in Rev C pub Jan 2000, section 6.9 Connector Pins - Press Fit Pins, applies to all press-fits? Or just individual pins (like an Autosplice pin)? Still wondering if I'm an idiot... -Steve Gregory- --------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/html/forum.htm for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ----------------------------------------------------- --------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/html/forum.htm for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 -----------------------------------------------------