Mark Mainland wrote:

>
>
> Hello,
> I've got a board that needs to be routed on a single side, I'm looking
> for some SMT jumpers that come on tape & reel. I have looked at
> Zierick but they only have a .300" & 1.5" size, does anybody have a
> source that has more sizes available?
>
> Thanks.
>

We have used 0 Ohm MELF resistors of 0204 or 0207 (metric) size. They are available on tape & reel.

You can route traces between pads. Zero Ohm 1206 chip resistors should work, too.

See http://www.bccomponents.com/Uploads/Datasheets/melpro.pdf on page 2 bottom right.

  Best regards

  Volkmar Huß C.I.D.

  Engineering Electronic Circuit Boards
  Aufbau- und Verbindungstechnik
  _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

  DRÄGER ELECTRONICS

  Draeger Electronics GmbH
  Moislinger Allee 53-55
  D-23558 Lübeck

  Tel:   +49-451-882-3998
  Fax: +49-451-882-4365
  mailto:[log in to unmask]
  Website http://www.draeger-electronics.com
  _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Important Notice
This email and any attachment hereto are confidential and may contain trade
secrets or may be otherwise protected from disclosure. If you have received
it in error you are in notice of this fact. Please notify us immediately by
reply email and then delete this email and any attachment from your system.
Please understand that you are not allowed to copy this email or any
attachment hereto or disclose its contents to any other person. Thank you.