Please note that Concoat has recently acquired the former Multicore SPCID
business. For more information, please visit our new web site
www.concoatsystems.com
Concoat Ltd
Alasan House, Albany Park,
Camberley, Surrey,
GU16 7PH
Tel: +44 (0) 1276 691100
Fax: +44 (0) 1276
691227
Attention: This message is for the named person's use only. It may
contain confidential, proprietary or legally privileged information. No
confidentiality or privilege is waived or lost by any mistransmission. If you
receive this message in error, please immediately delete it and all copies of it
from your system, destroy any hard copies of it securely and notify the sender.
You must not, directly or indirectly, use, disclose, distribute, print, or copy
any part of this message if you are not the intended recipient. Concoat Ltd and
any of its subsidiaries each reserve the right to monitor all e-mail
communications through its networks.
Any views expressed in this message are
those of the individual sender, except where th
----- Original Message -----
Sent: Friday, June 14, 2002 7:05 PM
Subject: [TN] fluxing the top side of
printed circuit board
Is it okay to either spray or apply flux to the
component side of the printed circuit board. We are using Kester 951 no clean
flux.
Thanking you,
Bob Arciolla