[log in to unmask]">
Because
breakout on an unsupported hole will prevent it from wave soldering correctly.
Neil
-----Original
Message-----
From: Mcmaster, Michael [mailto:[log in to unmask]]
Sent: 26 June 2002 01:15
Subject: Re: Definition of
Supported/ unsupported hole
So if it's unplated, why
does an unsupported hole have a breakout (or more appropriately a "no
breakout") requirement (IPC-6012 Table 3-5)?
----------
From:
Neda
Thrash[SMTP:[log in to unmask]]
Reply To:
TechNet E-Mail Forum.;Neda Thrash
Sent:
Tuesday, June
25, 2002 1:36 PM
To:
[log in to unmask]
Subject:
Re: [TN] Definition of Suported/ unsupported hole
Peter, a supported hole
in a PWB is plated through the board according to IPC-T-50 (Terms and
Definitions for Interconnecting and Packaging Electronic Circuits) " or
otherwise reinforced". The unsupported holes do not contain plating.
>>>
[log in to unmask] 06/25/02 02:22PM >>>
Technet,
Can anyone explain the
difference between a supported
and unsupported hole on PCB?
I am reading a section
on IPC-A-600 RevF and section
2.10.3/4 specify difference acceptance criteria
according to the hole type.
Rgds,
Peter
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by
IPC using LISTSERV 1.8d
To unsubscribe, send a message to
[log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF
Technet
To temporarily halt delivery of Technet send
e-mail to [log in to unmask]: SET Technet NOMAIL
To receive ONE mailing per day of all the posts:
send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at
[log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by
IPC using LISTSERV 1.8d
To unsubscribe, send a message to
[log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF
Technet
To temporarily halt delivery of Technet send
e-mail to [log in to unmask]: SET Technet NOMAIL
To receive ONE mailing per day of all the posts:
send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at
[log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------