How was this tested for reliable results and cleaning method?

-----Original Message-----
From: McMullen, Kerry [mailto:[log in to unmask]]
Sent: Thursday, February 28, 2002 4:59 PM
To: [log in to unmask]
Subject: Re: [TN] FW: Water soluble w/BGA


We have success where we use WS on 1mm pitch BGAs and 1.25 mm pitch BGAs.
For .8mm pitch BGA's we use no clean.  Cannot remove the flux residue from
under them efficiently.

-----Original Message-----
From: Chris Christian [mailto:[log in to unmask]]
Sent: Thursday, February 28, 2002 4:33 PM
To: [log in to unmask]
Subject: Re: [TN] FW: Water soluble w/BGA


I would be the first to admit I am not an expert, but cleaning under a low
stand-off BGA is a major problem.   And water soluble flux residues are
definitely not something you want left on a board.

Chris Christian
Indium Corporation of America

-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of Mary Jane Chism
Sent: Thursday, February 28, 2002 3:11 PM
To: [log in to unmask]
Subject: [TN] FW: Water soluble w/BGA





-----Original Message-----
From:   Mary Jane Chism
Sent:   Thursday, February 28, 2002 2:27 PM
To:     [log in to unmask]
Subject:        Water soluble w/BGA

I wanted to present this question out to the experts; What do you think
about the validity of using water soluble flux with BGAs? Do you see a
"residue" issue? Thanks.

Mary Jane Chism