It's the same old story a fight for love and glory. Ah, it takes me back to Casablanca, or was that BF Montana where my social club was to have been built, but for the fire making that impossible, repreat with lamination press and dungeon. No, not me! Yes, the press plattens must be ASSured flat and parallel without nicks and dings. Use lead strips to determine and check out the heater elements. Why do we go through this so often. Hell, now I'm talking to myself. I know, I should be kinder, and usually am, but my recent bout with HIGHLY QUALIFIED SUPPLIERS makes me crazy = but that keeps me from going insane, right? I guess, I'm really talking to all the super designers out there, again, about supplier qualification. It just has to get done better and I didn't do a good job this time. I especially didn't evaluate my client as being even capable of understanding the process or need. These folks just wanted results in the shortest possible time and the lowest damn cost. I'm done, MoonMan --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site http://www.ipc.org/html/forum.htm for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------