Hello Folks: Does anyone know of an accepted standard for pull strength for a .025" through hole solder joint in an .062 board ? Also, is there an accepted strength spec for the hole barrel to the PC board, meaning pulling the hole barrel out of the board ? Thanks, __________________________________________________ Do You Yahoo!? Check out Yahoo! Shopping and Yahoo! Auctions for all of your unique holiday gifts! Buy at http://shopping.yahoo.com or bid at http://auctions.yahoo.com --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------