Hello Peter, try this web site for rubber boots: http://www.kinnarney.com/ I think that the amount of bottom side parts to be mask, will determine if a rubber boot will work, or a solder fixture may be a better option. If you are using a stand alone solder fountain, fixtures can be tricky to position over the fountain! If you have any questions about the fixture end of things, contact me off line. Regards, Eric Miller Sales Manager Ascentec Engineering 13565 SW. Tualatin-Sherwood Rd. Suite 400 Sherwood, Oregon. 97140 PHONE: 503-925-1942 Fax: 503-925-1191 -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of peter lee Sent: Wednesday, September 05, 2001 9:18 AM To: [log in to unmask] Subject: [TN] Mask for selective soldering Hello, Does anyone know of any masking boot one could put on a board to sustain selective wave soldering? If so, what styles and sizes are available? The boards are being soldered on a wave dipping machine and the adjacent components were masked with kapton tape to prevent the heat and molten solder during the process. Rgds, Peter __________________________________________________ Do You Yahoo!? Get email alerts & NEW webcam video instant messaging with Yahoo! Messenger http://im.yahoo.com ------------------------------------------------------------------------ --------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ------------------------------------------------------------------------ --------- --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------