Tamir,
If you are looking for an equation, try this:
( 1/2 max thickness of V-cut ) + ( location tolerance of V-cut from nominal
edge ) + ( your standard component distance from pcb edge )
Rgds,
Roger M. Stoops, C.I.D., PCB Designer


Trimble
Engineering and Construction Division




                    Tamir Ben
                    Shoshan              To:     [log in to unmask]
                    <[log in to unmask]        cc:
                    OM>                  Subject:     [TN] Distance from V-cut
                    Sent by:
                    TechNet
                    <[log in to unmask]
                    ORG>


                    09/03/01
                    08:03 AM
                    Please
                    respond to
                    "TechNet
                    E-Mail
                    Forum."





Hello,

Is there any recommendation for the distance between a component and the
V-cut edge?

Thanks, Tamir B. Shoshan.

---------------------------------------------------------------------------------

Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET
Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for
additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
---------------------------------------------------------------------------------

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------