With all the discussion of ENIG, I was wondering if there are any 'standards' as to the thickness of the immersion gold and nickel? Anyone care to share what information you spec to your PCB vendor to ensure you get the finish you want? Thanks in advance, Rick Thompson Ventura Electronics Assembly 2655 Park Center Dr. Simi Valley, CA 93065 +1 (805) 584-9858 x-304 voice +1 (805) 584-1529 fax [log in to unmask] --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------