What is the width/space tolerance? Gary McCauley PC Boards, Inc. -----Original Message----- From: Darrel Therriault [mailto:[log in to unmask]] Sent: Wednesday, August 29, 2001 2:14 PM To: [log in to unmask] Subject: [TN] Mfg Capability TechNet, Got a question about Mfg allowance for 2 oz Cu fabrication. Will there be any problems with 8 mil space/trace using 2 oz Cu or are there some design tweaks needed?? Tks.....DT -- Darrel Therriault VP, Mfg. Operations INCEP Technologies, Inc (858)547-9925 223 [log in to unmask] ---------------------------------------------------------------------------- ----- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------- ----- --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------