I asked around here and the word was that both Fuji and Hover-Davis should make a deep enough feeder but Hover-Davis will be less expensive. (He had seen an 800 mil deep feeder.) A shorter nozzle might be needed and an adjustment in the pick&place program to give you a rotation for a horizontal transfer and another rotation to a (normal) vertical placement. Dorothy > ---------- > From: Tempea, Ioan[SMTP:[log in to unmask]] > Reply To: TechNet E-Mail Forum.;Tempea, Ioan > Sent: Tuesday, August 07, 2001 12:08 PM > To: [log in to unmask] > Subject: Fuji IP3 feeders > > Hello again, > > this is for the ones suffering in the contract manufacturing world due to > the high flexibility we need. > > The problem is that I have a .500" high part in a 44mm wide tape and the > feeders available from Fuji and Hover-Davis can only accomodate parts > .400" > high, at best. I spent all the morning to figure out if I could mill the > feeder. No way! > > So the question is: does anybody know of other sources of Fuji IP3 feeders > that make what I need. > > Many thanks, > Ioan > > -------------------------------------------------------------------------- > ------- > Technet Mail List provided as a free service by IPC using LISTSERV 1.8d > To unsubscribe, send a message to [log in to unmask] with following text in > the BODY (NOT the subject field): SIGNOFF Technet > To temporarily halt delivery of Technet send the following message: SET > Technet NOMAIL > Search previous postings at: www.ipc.org > On-Line Resources & Databases > > E-mail Archives > Please visit IPC web site (http://www.ipc.org/html/forum.htm) for > additional > information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 > ext.5315 > -------------------------------------------------------------------------- > ------- > --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------