Good Morning. As part of a design mod, I have been requested to remove 2 Through Hole resistors from one of our assemblies. There are @2000 boards. What is the recommended process for removing Through Hole capacitors. Is there any IPC guidelines? I would like to just clip the leads on the top and bottom of the board for an easy rework. This will leave part of the leads soldered in the holes, but I am not aware of any issue with this apart from the fact it may not look pretty! Any advice would be much appreciated. Thanks again, John --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------