Good Morning. I'd like to get some input on what type of equipment some of you experienced folks have used to depanel PCB's. I have used Hydraulic punch press and Pizza cutter type equipment previously, but am looking for any other viable options to depanel a 16 up panel to individual boards. Our CM currently break these by hand after assembly(fortunately it is a thick fab,)and we are looking to purchase a pizza cutter again, but I would like to investigate any other options. What are your experiences and suggestions. Thankful as always for your advice. JF --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------