Hello Netters, Does anyone know of company that can do ICT and Burn-In Testing within same facility? Here is my situation: We need an Outside source to do initial testing of 45 pcs of an assembly. Test Requirements: 1. Genrad 2286 Test Platform, All digital pins are high speed, relay driver board, SVS power supply, AFTM board, and IEEE Fluke model 1953A Counter/Timer. We should be able to supply the Test Fixture Head and Test Programs. 2. Node count is about 1500-1600. 3. Perform Genrad ICT testing before and after burn-in. (2) test required. Burn-In Requirements: 1. Total Duration of 96 hours. 2. 8 hour cycles consisting of 4 hours @60C, then 4 hours @10C, with 30 minute transition between extremes. 3. Power cycling of Assembly shall be performed during Burn-In with 27 minutes "ON" and 3 minutes "OFF". Extra: 1. Would like for company performing test to provide Diagnostic's and Repair of "ICT" Failure of initial units. 2. We will provide parts to facilitate repairs. Tom Braswell Fawn Industries 6441 East NC 97 Elm City, NC 27822 Ph: (252) 977-8745 Fx: (252) 977-3477 Email: [log in to unmask] --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------