Steve, Our first thought on the picture was that is should work. However, on the right side of the pad, where the measles tend to join, my colleagues and I thought that it may be possible that there may be the start of some delamination underneath the pad. If this was the only area effected, outside of the repair area, I would not be worried except for the possibility of delamination. Good Luck. Lee Whiteman Senior Manufacturing Engineer E-Mail: [log in to unmask] Ph: (610) 362-1200 x208 Fax: (610) 362-1290 -----Original Message----- From: TechNet [mailto:[log in to unmask]]On Behalf Of Stephen R. Gregory Sent: Monday, June 04, 2001 2:58 PM To: [log in to unmask] Subject: [TN] Measling... Hi ya'll! I took a few days off last week, and came back to be confronted with some boards that have been measled from rework... Go to: http://stevezeva.homestead.com/index.html to take a peek. The boards are polyimide, and it obviously appears that there was too much heat used when they were reworked...also they may have not been baked prior to the rework...I was told that they were, but you know how that goes. I know what the -610 says about it, it says it's acceptable as long as the assembly performs as specified. There isn't any burns or anything around any of the barrels, just the measles...and it's only on one 14-pin DIP location. Would any of you have any REAL hesitation about accepting this assembly? Thanks! -Steve Gregory-