Kathy, Thank you for your response. Your standard would solve our problem. I'm not sure if we could get our vendor to send in a roll. Perhaps we should keep a poka yoke around for inspection. A poka yoke would be a sample with all of the correct components on it. Again, thank you! Regards, Kevin Peralta -----Original Message----- From: Kathy Kuhlow [mailto:[log in to unmask]] Sent: Friday, May 11, 2001 1:18 PM To: [log in to unmask] Subject: Re: [TN] Inspection Our standard is that if a part can not be positively identified on the part itself. The original reel would be verified to a component on the assembly and a component off of the reel. They must match (color, termination style, width, length). If the part is still not able to be identified then a component will be removed and tested with the appropriate test equipment. Kathy