Sure it is possible. The shop would probably do the LPI process before the screen printed mask. Cannot comment on the cost, that could vary from shop to shop but it should not be a prohibitive cost. Regards John Parsons Circuit Graphics Ltd. > -----Original Message----- > From: TechNet [mailto:[log in to unmask]]On Behalf Of F.Pitzl > Sent: Thursday, April 19, 2001 10:39 AM > To: [log in to unmask] > Subject: [TN] Improved SlkScreen requirements > > > Hello, > > At this day I was asked by our engineer if it is possible to put a > additional silk-screen onto the board. > This additional silk-screen has to be in a different color than the > board and the normal one. Even it should have the same clearance and > minimal line width requirements as a Solder Mask. For this it must be a > photoimageable process. > > What would you say to this issue ? > Is it possible to run a second "SolderMaskProcess" with a different Mask > and color and how much would it cost on your opinion ? > > Regards, > Florian Pitzl --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------