We've been asked to do a small proto run of flip-chip assemblies. I'm looking for some insight on how best to underfill these parts. Is manual equipment sufficient to do this? Any input as to materials & methods would be appreciated. Thanks in advance, Rick Thompson Ventura Electronics Assembly 2655 Park Center Dr. Simi Valley, CA 93065 +1 (805) 584-9858 x-304 voice +1 (805) 584-1529 fax [log in to unmask] --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------