Tervor, I would guess it depends on the skill of the reballer. Our CM reballs many of our parts and we have had no problems. DT -----Original Message----- From: Trevor Goddard [mailto:[log in to unmask]] Sent: Wednesday, February 07, 2001 12:05 PM To: [log in to unmask] Subject: [TN] Hi everyone Does anyone know about reballing BGAs, in regards to reliability. Is the possible cost savings worth the risk. Thanks in advance Trevor Goddard, SMT Supervisor XLTEK (905) 829-5300 x 348 [log in to unmask] <mailto:[log in to unmask]> ---------------------------------------------------------------------------- ----- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------- ----- --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------