To my esteemed colleagues, We had a customer visit today and the topic of "pull testing of crimped wire terminals" came up. We haven't been testing these formally. Do any of you get into crimping of discrete wires and then performing a pull test? What equipment is required to accomplish this task. And the all important one, to what standard should we work? Phil Nutting Manufacturing Engineer Kaiser Systems, Inc. High Voltage Power Supplies That Work(tm) 126 Sohier Road Beverly, MA 01915 ph: 978-922-9300 fx: 978-922-8374 www.kaisersystems.com [log in to unmask] --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------