Hi Technet, One of our buyers informed engineering that our specs indicate that board shops may not repair traces if they are narrower than 8 mils. It was brought to our attentions because they think the spec is out of date. I tend to agree, but I don't know what the acceptable limitation is. Can anyone tell me what the minimum acceptable trace width is that repairs will be allowed? Thanks Ryan Grant Advanced Technology Engineer MCMS (208) 898-1145 [log in to unmask] --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------