Hello Everyone, I work for a component manufacturer and I have been trying to locate information on a specific type of termination for components. I realize that the majority of the subscribers to Technet are associated with circuit board construction and not component level construction but hopefully someone may have seen or heard something that might be of assistance. I am seeking information on clip-type, wraparound, termination like the one's seen at this webpage: http://www.minicircuits.com/dg00-72.pdf. Any input would be most appreciated. Thank you Technetters. Best Regards, Mark Gilbert, Product/Process Engineer FOX Electronics For Frequency Control Solutions. . . Fast: 1-888-GET2FOX, ext. 289 Fax: 941-693-1554 http://www.foxonline.com/ --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------