Simon, Just back from an unexpected week off. As a fellow RAD2 owner, if you still need help, please do not hesitate to contact me. Richard Hamilton Clemar Mfg. / Rain Bird [log in to unmask] > -----Original Message----- > From: Simon Howells [SMTP:[log in to unmask]] > Sent: Tuesday, January 09, 2001 2:28 PM > To: [log in to unmask] > Subject: [TN] PCB Design for Radial Insertion > > Hi All, > > Does anyone know of some PCB design guidelines for boards that use radial > insertion, eg; clearance insertion paths etc. > The machines that we will use are older Universal Rad "2" 5.04mm component > pitch > inserters. > > The reason for this is we are reviewing a design that uses radial > insertion > topside, surface mount bottom side and wave soldering. > > Any help would be greatly appreciated. > > Thanks. > > Regards, > Simon Howells > Senior NPI Project Engineer > Solectron Telecommunications Pty Ltd, > Tel. 02 8778 1687 Mob. 0418 400 394 Fax. 02 8778 1555 > > Email: mailto:[log in to unmask] > Web: http://www.solectron.com > > -------------------------------------------------------------------------- > ------- > Technet Mail List provided as a free service by IPC using LISTSERV 1.8d > To unsubscribe, send a message to [log in to unmask] with following text in > the BODY (NOT the subject field): SIGNOFF Technet > To temporarily halt delivery of Technet send the following message: SET > Technet NOMAIL > Search previous postings at: www.ipc.org > On-Line Resources & Databases > > E-mail Archives > Please visit IPC web site (http://www.ipc.org/html/forum.htm) for > additional > information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 > ext.5315 > -------------------------------------------------------------------------- > ------- --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------